Powerleap PL-iP3 Manual page 13

Configuring the PowerLeap™ PL-iP3
As mentioned in the previous chapter, the method that your motherboard provides
for setting the FSB speed will determine the frontside bus speed setting that you
choose on the PL-iP3.
•
If your motherboard has jumper switches for setting the FSB speed, the
PL-iP3's jumper switches (JP1 and JP2) will override the motherboard
settings on the condition that the motherboard's FSB speed jumpers are set to
"automatic". If the motherboard's FSB setting is set to a specific speed, the
PL-iP3's speed setting will have no effect (be overridden).
•
If your motherboard offers "jumperless" speed configuration through
settings in BIOS, the PL-iP3's speed setting will have no effect (be
overridden).
•
If your motherboard offers "jumperless" speed configuration by
automatically setting the FSB speed to the FSB rating of the CPU, you can
use the PL-iP3's jumper switches (JP1 and JP2) to change the FSB speed.
For Celeron users: Intel has set the FSB rating for Celerons to 66MHz. Please select
the 66MHz setting (the default) shown below.
JP1
FSB
Jumpers
FSB Jumpers Location Diagram
JP1 JP2
Closed Closed
FSB Setting
for 66MHz
9
PowerLeap Installation Guide
™