Flow Chart Of Switching Driver Running - Alpha AS600M Series Manual

Display
0.00
of LED
PRG
Operation
ESC
of key
go into
monitoring
programming
state
state.display
parameter
group menu
PRG
ESC
Exit from
the
programming
state
In three-level menu state, no flicker digit for a parameter indicates that the function
code cannot be modified, and the possible reasons include:
 Modifying the value is forbidden because the parameter is actual measure value,
or running record value or fixed value.

The function parameter cannot be changed when the driver is at running state.
However, it can be changed at stop state. So stop the driver and then change the
parameter value.
 The driver parameters are protected. If function parameter value PF.01=1 or 2, the
parameters are forbidden to be changed. This parameter protection function is to
avoid operation mistake. To change the protection parameters, change value of
function code PF.01 to zero, then all the parameters can be changed

3.2 Flow chart of switching driver running

The flow chart of switching driver running is shown in Fig 3-6. CNC system uses the
pulse command and bipolarity analog AI2 or unipolarity analog AI1 to control
AS600M run in speed control mode . And CNC system uses the pulse command and
bipolarity analog AI2 to control AS600M run in position control mode. Position control
and speed control mode can be switched through the terminal X5 rigid tapping/pulse
position.
-P0- -P2-
+
ENTER
ENTER
Enter
turn right 2
into
times,chose
parameter
parameter
code
group P2
number
menu
-P2-
PRG
ESC
Exit to
parameter
group
menu
Figure 3-5 Flow chart of parameter setting
P2.00
P2.01
+
ENTER
turn right 1
Enter into
time,chose
parameter
parameter
value menu
code
numberP2.01
003.2
P2.02
ENTER
save the
Turn right 2
changed value
times to
and exit to
change the
parameter
number to
code number
menu
Chapter 3 Operation
006.0 003.0
-
Turn left 3
times to
chang the
number to 3
003.0
＞＞
+
Shift to
change the
blinking
2 place to
right
25