Step 5: Perform The Initial Software Configuration For The C Series Controller; Setting Up Management Access And Logging In - Juniper C Series Quick Start Manual

Step 5: Perform the Initial Software Configuration for the C Series Controller

Setting Up Management Access and Logging In

Copyright © 2013, Juniper Networks, Inc.
Step 5: Perform the Initial Software Configuration for the C Series Controller
CAUTION: Ensure that each cable lug seats flush against the surface of
the terminal block as you tighten the screws.
Verify that the DC source power and grounding cabling are correct, that they are not
6.
touching or blocking access to controller components, and that they do not drape
where people could trip on them.
Replace the clear plastic shield over the field-wiring terminals.
7.
Turn on the current from the power source so that voltage flows to the controller.
8.
Figure 9: Connecting DC Power Cables to the Controller
Setting Up Management Access and Logging In on page 9
Configuring the Juniper Networks Database on page 10
Configure Hostname and Domain Parameters on page 10
Configure the System for Remote Access on page 11
Configure the System to Accept SSH and Telnet Connections on page 11
Add an Admin User Account on page 12
To log in to the system:
9