Using Sequoia - Parrot Sequoia User Manual

Note: If Sequoia detects an SD card the shots are saved on this
SD card. If no SD card is detected, Sequoia automatically saves
the shots in its internal memory.
Remove the protective lens cover
Use the protective lens cover before using Sequoia.
The protective lens cover is used for transportation it has to be removed
before use.
Attaching Sequoia to a drone
Sequoia can be attached to all types of drones.
1. Select the sunshine sensor holder which is most suitable for your
drone.
2. Remove the plastic film from the holder and stick the holder on the
back of the drone.
The holder must be positioned parallel to the drone (diagram
!
A).
3. Insert the sunshine sensor in its holder.
To avoid distorting the data the sunshine sensor must not be
!
covered during photo shoots.
4. Insert the multispectral sensor under the drone, in the kit provided
for this purpose.
5. Connect the multispectral sensor to the sunshine sensor using the
USB host cable.
6. Connect the multispectral sensor to the drone using the USB
device cable.
> Sequoia turns on automatically (Diagram B).
18

USING SEQUOIA

Diagram A