Table of Contents
Advertisement
Quick Links
Quick Start of Blue gate ISDN Brave
Install BlueGate ISDN Brave Configuration software on your PC. Please, follow instructions in Installation.pdf.
Does SIM card have
PIN code?
No
Synchro
TE mode
Set switches for terminal rezistors
Open the box and set switches for terminal rezistors.
There are 4 switches for connecting 100 Ohm terminal rezistors. Switches 1, 2 are used
for TE mode, switches 3, 4 are used for NT mode.
Default setting is TE - off, NT – on
(Synchro mode).
Find out PIN code (at various mobile phone ) and remember it.
Yes
When you run Configuration SW you can type it in configuration data.
Start
Router
Mode?
Advertisement
Table of Contents
Summary of Contents for Alphatech Blue Gate ISDN BRI Brave
- Page 1 Quick Start of Blue gate ISDN Brave Start Install BlueGate ISDN Brave Configuration software on your PC. Please, follow instructions in Installation.pdf. Synchro Router Mode? TE mode Set switches for terminal rezistors Open the box and set switches for terminal rezistors. There are 4 switches for connecting 100 Ohm terminal rezistors.
- Page 2 Insert SIM card By pressing of yellow button release the SIM card holder. Insert the SIM card and replace the SIM card holder. Insert antenna The available place for installation select up following point of view: 1. Distance from PBX lines – possibility of GSM interferences 2.
- Page 3 You can assign the name of your equipment Set at least the following parameters: Blue Gate Brave1 If you want to use network connection set all parameters. Choose the proper Dial tone · Select the mode that you want to use Suppose you set the correct switches for connecting 100 Ohm terminal resistors Set parameters for NT mode according...
- Page 4 Include the GSM modules GSM1 and GSM2 to the appropriate groups. Type PIN code if there is one 1234 If you use DISA (Direct Inward System Access) set time ≠ 0 and also set the min. and maximum length of DTMF digits In case of Synchro mode or Router mode select A-NT In case of ISDN mode TE...
- Page 5 You can EDIT default routing profile and set all routing items IIn case of Synchro mode or Router mode select A-NT In case of ISDN mode TE select output line B-TE All calls from Input line A-NT will be routed to GSM network (Outgoing Group 1) In router mode if any item is not in Routing table all calls are routed from the PBX to the PSTN and vice versa.
- Page 6 Now it is time to save your setting into device. After 40 seconds the Led of GSM starts fast blinking. Then if GSM is registered and full service, the Led is blinking slow. In another case see in Bluegate ISDN Brave Configuration in Diagnostics ->GSM Modules Status what is the matter.
Need help?
Do you have a question about the Blue Gate ISDN BRI Brave and is the answer not in the manual?
Questions and answers