Emerson Bettis BHH Series Installation, Operation And Maintenance Manual page 26

Section 6: Mounting 90° Turn Set
December 2019
1. Start with placing the drill in the hole in the jig a
shown in the picture. The hole functions as presetting
of the drilling length.
3. The jig is mounted on the actuator.
5. The thread expander is mounted in the hole in
the shaft.
7. Thread expander mounted in shaft.
NOTE:
Actuators manufactured from 2015 and forward are delivered with M3-tread in shaft end.
21
Installation, Operation and Maintenance Manual
Mounting of 90° Indicator Turn Set
2. Place the drill socket on the drill as shown on the
picture. The drill socket must be as closely as possible
to the jig when it is tightened.
4. Drill until the socket reaches the jig.
(Depth of the hole 7.5 mm)
6. Place the enclosed pin in the hole of the
expander. Knock the pin slightly to fix the thread
expander.
8. The indicator is placed on the position shaft, so
that tongue and groove fit, and the M3 screw is
mounted.
MAN-02-05-62-0742-EN Rev. 0
Mounting 90° Turn Set