Operation - Bauer HYPERMAX 191101C-B Owner's Manual & Safety Instructions

Operating instructions
read the EntirE iMpOrtant SaFEty inFOrMatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO prEVEnt SEriOuS inJury FrOM acciDEntaL OpEratiOn:
Make sure that the trigger is in the off-position and remove the Battery
pack before performing any procedure in this section.
tO prEVEnt SEriOuS inJury:
DO nOt OpEratE WitH any GuarD DiSaBLED, DaMaGED, Or rEMOVED.
Wear anSi-approved splash-resistant safety goggles, niOSH-approved dust mask/respirator under
face shield, and heavy-duty LEatHEr gloves, and other appropriate protective equipment when
setting up the Drain cleaner. For extra protection from chemicals and bacteria on the appliance and
in the work area, wear latex, rubber or other liquid barrier gloves under the heavy-duty LEatHEr
work gloves. Before use, inspect gloves to be sure they are free of defects or loose sections that could be
caught in the Drain cleaner cable. rubber soled, non-slip shoes can help prevent slipping and
electric shock, especially on wet surfaces.
tO prEVEnt SEriOuS inJury FrOM ELEctric SHOcK, tWiStED/BrOKEn caBLES, cHEMicaL BurnS,
inFEctiOnS anD OtHEr cauSES anD prEVEnt Drain cLEanEr DaMaGE:
Before each use, inspect Drain cleaner and correct any problems.
1. Inspect the tool for broken, worn, missing,
misaligned or binding parts or any other condition
which may prevent safe and normal operation.
2. Check the Cable for wear and damage.
Replace Cable before use if any section:
a. is worn or flattened,
b. is kinked more than 15°,
c. has spaces between coils (often caused by
running motor in reverse or pulling on cable),
d. shows signs of corrosion.
3. Install the Drain Plug and make
sure it is properly tightened.
Page 8 For technical questions, please call 1-888-866-5797.
4. Make sure that switches and handles move
smoothly between positions and lock in place.
5. Check that all warning labels are present,
firmly attached and readable.
6. Before use, fully retract the Cable with
no more than 2" of Cable outside of the
appliance. This will the keep the Cable from
"whipping" when the appliance is turned on.
7. Clean any oil, grease or dirt from all equipment
handles and controls. This helps prevent the
appliance or control from slipping during use.
Item 64483