Toro TX 427 Quick Start Quide page 2

5. Turn the high idle adjusting screw outward to lower the
RPM to between 3200 and 3300 RPM.
Important: If you exceed 3300 RPM, the engine
will not be in compliance with CE regulations and
cannot be legally sold or used in the European
Community.
6. Secure the screw with the jam nut, checking the engine
RPM again as you do so.
7. Slide the small aluminum tube over the high idle
adjusting screw and jam nut.
8. Crimp the tube down to the screw shaft with a pliers
between the screw head and the jam nut so that the jam
nut cannot be loosened in the future.
Important: The tube must be fully over the jam
nut to prevent access to it.
9. Close the hood and tighten the hood locking screw.
Important: You must tighten the hood locking
screw to ensure that the hood cannot be
accidentally opened without tools, complying with
CE safety regulations.
Installing the Production Year
Decal (CE Only)
If you are setting up this machine for use in the European
Community, you need to add the production year decal to the
machine. Install the decal just above the serial plate on the
machine, following the instructions provided on the decal.
2