Front Control Panel Layout - Komet 19 Owner's Manual

THANK YOU FOR PURCHASING THE KOMET
The Komet is a straightforward and easy to operate amplifier. The goal of this manual is to
19

help you get acquainted
"
capable sounds.

FRONT CONTROL PANEL LAYOUT

1. Input Jack: accepts standard ¼ inch plug. Input impedance is 1 Megohm.
2. Bright Switch: three way selector switch. Middle position is off. Down position -
bright. Up position - most bright.
3. Volume Control: adjusts
4. Saturation Control: a gain control that increases the guitar signal from natural clean into a
smooth harmonic overdrive range. Please keep in mind that the effect of this control
is interdependent with the setting of the amplifier's volume control.
5. Tone Control: adjusts
Experiment with this control to find the settings that best suit your playing style.
6. Pilot Light: illuminates when power switch is in
# 47 light bulb.
(6.3 Volt)
7. Standby Switch: allow the amp to warm up for 60 seconds before engaging the standby
switch to the play position. This action allows for the tubes' filaments to heat up to the
proper voltage required for operation. This procedure will prolong the lifespan of the
amplifier's tubes.
8. Power Switch: engages the AC wall power to the amplifier.
Copyright 1999-2017, KometAmplification. Group, L.L.C. May not be reproduced in any form without express written consent from KometAmplification.
with your Komet amplifier, and how to make use of its many
"

the overall level and gain of the amplifier.
(clockwise)
) the low to high end range of frequency equalization.
(clockwise
(See trouble shooting section for replacement instructions).
19 AMPLIFIER

(left to right):
position. The pilot light uses a type
"On"