Front Control Panel Layout - Komet Songwriter 30 Owner's Manual

Thank you for purchasing a Trainwreck
The Komet Songwriter

this manual is to help you "get acquainted " with your Komet
use of its many capable sounds.

FRONT CONTROL PANEL LAYOUT

1. Power Switch: engages power to amplifier.
2. Standby Switch: allow the amplifier to warm up for 60 seconds before engaging the
standby switch to the play position. This action allows for the tubes to heat up to the
proper voltage required for operation and will help prolong the lifespan of your tubes.
3. Pilot Light: illuminates when power switch is in "
type #47
(6.3 Volt)
counterclockwise and remove. Now the bulb is exposed. Using the tips of your
fingers, gently push and turn the bulb counterclockwise, extract bulb and replace.
Note: Your amplifier will continue to operate with no problem with a shorted bulb or
with no bulb at all.
4. Bass Control: controls low end bass range frequencies.
5. Volume Control: adjusts
6. Treble Control: controls high end treble range frequencies.
7. Bright Switch: Three way selector switch.
slightly bright,
either position of brightness, is subtle. See special note towards end of manual.
8. Input Jack: accepts standard ¼ inch plug. Input impedance is 1 Megohm.
Copyright 1999-2017, KometAmplification. Group, L.L.C. May not be reproduced in any form without express written consent from KometAmplification.
is a straightforward and easy to operate amplifier. The goal of
30
light bulb. For bulb replacement, gently turn the jewel lens cap
the overall level and gain of the amplifier.
(clockwise)
position most bright.
Up
-
Engineered Komet

TM
 amplifier, and how to make
(left to right):
" position. The pilot light uses a
On
position is off,
Middle
the brightness factor of this switch, in
Note:
Amplifier.
TM
position
Down
-