Chapter 29 System Maintenance And Smt Menu 24.8 To 24.10; Command Interpreter Mode; Figure 29-1 Menu 24 System Maintenance; Figure 29-2 Valid Ci Commands - ZyXEL Communications ZyAIR Wireless Gateway Series User Manual

System Maintenance and SMT Menu

29.1 Command Interpreter Mode

The Command Interpreter (CI) is a part of the main system firmware. The CI provides much of the same
functionality as the SMT, while adding some low-level setup and diagnostic functions. Enter the CI from
the SMT by selecting menu 24.8. See the included disk or the zyxel.com web site for more detailed
information on CI commands. Enter 8 from Menu 24 – System Maintenance. A list of valid commands
can be found by typing help or ? at the command prompt. Type exit to return to the SMT main menu
when finished.
Copyright (c) 1994 - 2003 ZyXEL Communications Corp.
ras> ?
Valid commands are:
sys
poe
ip
cnm
ras>
System Maintenance and SMT Menu 24.8 to 24.10
This chapter leads you through SMT menus 24.8 to 24.10.
Menu 24 - System Maintenance
1. System Status
2. System Information and Console Port Speed
3. Log and Trace
4. Diagnostic
5. Backup Configuration
6. Restore Configuration
7. Upload Firmware
8. Command Interpreter Mode
9. Call Control
10. Time and Date Setting
11. Remote Management Setup
Enter Menu Selection Number:

Figure 29-1 Menu 24 System Maintenance

exit device
pptp config
ppp bridge
radius 8021x

Figure 29-2 Valid CI Commands

ZyAIR Wireless Gateway Series User's Guide
24.8 to 24.10
ether
wlan
hdap
Chapter 29
29-1