Port Switch; Reset Button - ZyXEL Communications ZyAIR Wireless Gateway Series User Manual

ZyAIR Wireless Gateway Series User's Guide
FEATURES
SPI/DoS prevention Firewall, including ACL
SSL Passthrough
Wi-Fi Protected Access (WPA)
Table Key: An "O" in a model's column shows that the model has the specified feature. A number specific
to an individual model may alternately be displayed. The information in this table was correct at the time
of writing, although it may be subject to change.

4-Port Switch

A combination of switch and router makes your ZyAIR a cost-effective and viable network solution. You
can connect up to four computers to the LAN ports on you ZyAIR without the cost of a hub.
10/100M Auto-negotiating Ethernet/Fast Ethernet Interface
This auto-negotiating feature allows the ZyAIR to detect the speed of incoming transmissions and adjust
appropriately without manual intervention. It allows data transfer of either 10 Mbps or 100 Mbps in either
half-duplex or full-duplex mode depending on your Ethernet network.
10/100M Auto-crossover Ethernet/Fast Ethernet Interface
The LAN interface automatically adjusts to either a crossover or straight-through Ethernet cable.
10/100 Mbps Ethernet WAN
The 10/100 Mbps Ethernet WAN port attaches to the Internet via broadband modem or router.

Reset Button

The ZyAIR reset button is built into the side panel. Use this button to restore the factory default password
to 1234; IP address to 192.168.1.1, subnet mask to 255.255.255.0 and DHCP sever enabled with a pool of
32 IP addresses starting at 192.168.1.33.
Brute-Force Password Guessing Protection
The ZyAIR has a special protection mechanism to discourage brute-force password guessing attacks on the
ZyAIR's management interfaces. You can specify a wait-time that must expire before entering a fourth
password after three incorrect passwords have been entered. Please see the appendix for details about this
feature.
1-2
Table 1-1 Model Specific Features
ZYAIR MODEL B-2000
O
Getting to Know Your ZyAIR
B-2000
V.2
O
O
O