Table of Contents
Advertisement
If you change the ZyAIR's IP address, you must use the new IP address if you want
Change the wireless parameter settings in the wireless stations to match those of the ZyAIR. Refer
4.
to the user's guide for your wireless adapter.
5 Hardware Mounting Installation
In general, the best location for the access point is at the center of your intended wireless coverage area. For
better performance, mount the ZyAIR high up free of obstructions.
Free-standing
Place your ZyAIR on a flat, level surface (on a desk or shelf) that is strong enough to support the weight of
the ZyAIR with connection cables.
Wall-mounted
Follow the steps to attach your ZyAIR to a wall.
Locate a high position on the wall that is free of obstructions.
1.
Connect two screws (not included) in the wall 75mm apart. Use screws with 6mm ~ 8mm (0.24" ~
2.
0.31") wide heads. Do not screw the screws all the way in to the wall. Leave a small gap between
the head of the screw and the wall. The gap must be big enough for the screw heads to slide into
the screw slots and the connection cables to run down the back of the ZyAIR.
Make sure the screws are securely fixed to the wall and strong enough to hold
Adjust the cables.
3.
a.
Run the connection cables down the back of the ZyAIR.
OR:
b. Run the connection cables upward and along the edge of the ceiling.
Align the holes on the back of the ZyAIR with the screws on the wall. Hang the ZyAIR on the
4.
screws.
ZyAIR B-500 Wireless Access Point
to access the web configurator again.
the weight of the ZyAIR with the connection cables.
13
Advertisement
Table of Contents
