Figure 2-4 Wizard Step 2 : Wireless Lan Setup Basic Security; Table 2-3 Wizard Step 2 : Wireless Lan Setup Basic Security - ZyXEL Communications Parental Control Gateway HS100/HS100W User Manual

HomeSafe User's Guide

Figure 2-4 Wizard Step 2 : Wireless LAN Setup Basic Security

The following table describes the labels in this screen.

Table 2-3 Wizard Step 2 : Wireless LAN Setup Basic Security

LABEL
WEP
Select 64-bit WEP or 128-bit WEP data encryption.
Encryption
ASCII Select this option in order to enter ASCII characters as the WEP keys.
HEX Select this option to enter hexadecimal characters as the WEP keys.
The preceding "0x" is entered automatically.
Key 1 to Key 4 The WEP keys are used to encrypt data. Both the HomeSafe and the wireless stations must
use the same WEP key for data transmission.
If you chose 64-bit WEP, then enter any 5 ASCII characters or 10 hexadecimal characters
("0-9", "A-F").
If you chose 128-bit WEP, then enter 13 ASCII characters or 26 hexadecimal characters
("0-9", "A-F").
You must configure all four keys, but only one key can be activated at any one time. The
default key is key 1.
Click Back to display the previous screen.
Back
Next Click Next to proceed to the next screen.
2.4.2 Step 2 : WLAN Setup Extended Security
If you choose Extend security in the Wireless LAN Setup screen, you can set up a Pre-Shared
Key.
2-4
DESCRIPTION
Introducing the Web Configurator