Chapter 23 Static Route Setup; Ip Static Route Setup; Figure 23-1 Menu 12 Ip Static Route Setup; Figure 23-2 Menu12.1 Edit Ip Static Route - ZyXEL Communications Parental Control Gateway HS100/HS100W User Manual

23.1 IP Static Route Setup

Step 1. To configure an IP static route, use Menu 12 – Static Routing Setup (shown next).
Step 2. Now, type the route number of a static route you want to configure.
The following table describes the fields for Menu 12.1 – Edit IP Static Route Setup.
FIELD
Route #
Route Name
Active
Destination IP
Address
Static Route Setup
This chapter shows how to setup IP static routes.
Menu 12 - IP Static Route Setup
1. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter selection number:

Figure 23-1 Menu 12 IP Static Route Setup

Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No

Figure 23-2 Menu12.1 Edit IP Static Route

Table 23-1 Menu12.1 Edit IP Static Route

This is the index number of the static route that you chose in menu 12.1.
Type a descriptive name for this route. This is for identification purpose only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing
is always based on network number. If you need to specify a route to a single
host, use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Static Route Setup
fi l
DESCRIPTION
HomeSafe User's Guide
Chapter 23
23-1