Bell D-180574 Manual

BELLSYSTEM PRACTICES SECTION 503-200-113
AT&TCo Standard Issue 1, September 1975
D-180574 TELEPHONE SET
1. GENERAL 2.05 The KS-19277 lock has been made inoperative.
1.01 This section contains identification, installation, 2.06 A D-180573 Kit of Parts completes the
maintenance, and connection information for redesign of the set (Fig. 4) as follows:
the D-180574Coin Decorator telephone set (Fig. 1).
(a) The L-170394 plate replaces the coin chute.
2. IDENTIFICATION (b) An L-170397 wooden block (Fig. 3) prevents
coins from falling into the return chute.
Design Features
(c) Dummy locks (840696942 and 840696959),
2.01 The set is a modified 236G coin collector, which can be operated with a screwdriver
The following items have been removed, or equivalent, are used in the upper housing
and cash compartment door, respectively.
• Information card holders and apparatus
blank. (d) A No. 10-32 by 3-inch RHM screw, No. 10-32
hex nut, and two No. 10-32 elastic stop nut
• Gong signal and chute assembly are used to mount the bell in the cash compartment.
• 452B capacitor (e) A 9-inch long sash chain is used to anchor
the cash compartment door to the set.
• Coin chute stop
2.07 All coins deposited will fall directly into the
• Coin relay assembly cash compartment.
• Coin trap and associated parts Markings
• 1A backplate 2.08 Markings 236G-3, 236G-51, or 236G-60 have
been removed and D-180574 stamped in the
• Coin vault spring same relative location. The letters CS, which
indicate customer sales, have been stamped on the
2.02 The starwheels on rear of coin guide have backplate adjacent to the vault area.
been cut off to provide clearance for adding
dummy chute (Fig. 2). Die cast webs across 5 Ordering Information
and 10 cent guides have also been removed.
2.09 Set, Telephone, D-180574 [Specify color;-03
2.03 The handset with armored cord has been (black),-51 (green),-60 (light beige)]
replaced with a G3A6-type handset with
6-foot retractable cord (Fig. 1). 2.10 Replaceable Components
2.04 The coin vane has been made stationary in (a) P-89E500* Lower Housing, consisting of:
the collect position by installing a No. 10
by 1-inch sheet metal screw through hopper (Fig. 3). • P-15E011 bucket assembly
© American Telephone and Telegraph Company, 1975
Printed in U.S.A.
Page 1