REXON RL-310D User Manual page 11

FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and
(2)
this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested
and found to comply with the limits for a Class B digital device , pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-
Reorient or relocate the receiving antenna.
-
Increase the separation between the equipment and receiver.
-
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-
Consult the dealer or an experienced radio/TV technician for help.
NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
Warning! :
The portable radio generates RF electromagnetic energy during transmit mode. This radio is designed for and classified as "Occupational Use Only,"
meaning it must be used only during the course of employment by individuals aware of the hazards and the ways to minimize such hazards. This radio is
NOT intended for use by the "General Population" in an uncontrolled environment.
The device complies with RF specifications when the device used at 25 mm from your front face and 0mm from your body, SAR compliance for body-worn
operating configurations is limited to the specific belt clip/ holster/accessories tested for this product. Body-worn accessories that do not meet these requirements
may not comply with RF exposure requirements and should be avoided. Maximum SAR Value (1g): 2.37 W/Kg.
The maximum permissible duty cycle is 50% during the operations.