Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for REXON RL-310D
Summary of Contents for REXON RL-310D
- Page 1 Digital Handheld Radio RL-310D...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Battery Low Setting! ......... PARTS NAME & FUNCTIONS! ....Battery Saving Setting! ......Front View! ..........Voice Announcement Setting! ....Sided View! ..........Hi/low Power Setting! ......ATTACHMENT! ........... SQL Level Setting! ........VOX Level Setting! ........Antenna! ............. -
Page 3: Parts Name & Functions
Sided View 1. Parts Name & Functions Front View (1) Antenna - The transceiver transmits or receives through the device to obtain maximum performance. (2) Status LED - Glows in different colors to show the current transceiver’s status. (3) Loudspeaker - The reception sound is emitted by built-in speaker located in this area. -
Page 4: Attachment
(6) External Speaker/Microphone Rubber - For external 2. Attachment microphone and speaker or programming the transceiver, Antenna user has to take the rubber out. (7) Microphone - Your voice is detected by the microphone Insert the antenna we supplied into the antenna located in this place. -
Page 5: Belt Clip
Belt Clip Replace The Battery Pack Attach the belt clip with 2 pieces of screws by Insert the battery back into chassis until hear the after screwdriver. kick sound. Remove the battery pack First turn off the radio and lift the lock button then pull the battery pack out. -
Page 6: Earphone/Speaker Microphone
Earphone/Speaker Microphone Take the cover out and plug the earphone/Speaker microphone into the jack. Page 4... -
Page 7: Charging The Battery
3. Charging The Battery The battery pack is not charged at the factory; charge it before use. Initially charging the battery pack after purchase or extended storage (greater than 2 months) will not bring the battery pack to its normal operating capacity. -
Page 8: Basic Operation
Transmission 4. Basic Operation Before transmitting, monitor the channel you are using Turn On/Off the transceiver to ensure it is not busy. Keep pressing PTT button and Switch ON the transceiver by turning the power start talking at approximately 2 inches from the MIC switch / volume control knob clockwise until a beep hole. -
Page 9: Hi/Low Power Setting
PTT ID Hi/low Power Setting (1) Pressed PTT button High power to communicate with long distance, low (2) Released PTT button power work with short distance, each channel to be (3) Both Pressed and Released ptt button. set high or low. SQL Level Setting 6. -
Page 10: Specifications
8. Specifications General Characteristics Units Value Frequency Range 400~470 Output power 5W /1W Channel Number KHz 12.5 / 25 Channel Spacing 4FSK Modulation Type Power Source 7.4VDC Antenna Impedance ohm 50 Battery type li-polymer Operation Temperature -20 to +55 Dimension 115x59x35 (H*W*D) Weights 274.8... - Page 11 FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and this device must accept any interference received, including interference that may cause undesired operation. NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to part 15 of the FCC Rules.
Need help?
Do you have a question about the RL-310D and is the answer not in the manual?
Questions and answers