Successful Pairing Indicators; Repeating The Pairing Process - Concourse Smart Wheels Quick Start Manual

6. Connect charger, wait for red light.
7. Disconnect charger, wait for light to extinguish.
8. This wheel should now successfully be paired to the remote.
There are some indicators that show that it has succeeded:
a. On the wheel, the LED should go BLUE momentarily, followed by GREEN.
b. On the remote side, the three BLUE LEDs should flash on and off three times.
9. Repeat steps 3-8 again for 2
wheel using either indicator 8a or 8b.
10. Remote will return to sleep, and pairing has now been fully established for both wheels.
If you exceed 50 secs performing this procedure, the remote will go
to sleep (as shown below by the following sequence of LEDs) and
you must start again by going back to step 2
nd
wheel. Keep an eye out for successful pairing of the second