parktool PRS-20 Quick Start Manual

Park Tool Co.
The PRS-20 Team Race Stand and PRS-21 Super Lite Team Race Stand are compact,
folding workstands that securely hold the bike without clamping the frame tubes or
seat post. Used by professional race mechanics around the world.
ASSEMBLY
1
2
3
4
© 2008 Park Tool Co.
® The color BLUE is a registered trademark and trade dress of Park Tool co.
6 Long Lake Rd. St. Paul, MN 55115 (USA) www.parktool.com
Team Race Stand
PRS-20 / PRS-21
UNFOLDING FOR USE
1. Loosen knob (#5) a yoke (#22). Raise upright tube
(#19) to desired height and tighten knob.
2. Open clamping collar quick release (#20) and lower
collar to yoke. Close quick release.
3. Unfold legs (#24).
4. Pull hitch pin (#11) and unfold horizontal beam tube
(#7). Reinstall hitch pin.
MOUNTING BIKE IN PRS-20/PRS-21
1. Remove front wheel of bike if clamping by front
dropouts. Remove both front and rear wheels if
clamping bike by rear dropouts.
2. Rest bottom bracket shell of bike into saddle (#9) of
PRS-20/21.
3. Loosen knob (#5) on slider (#3). Position slider so
front or rear dropouts of bike fit over slider¹s front or
rear axle. Lock dropouts with front quick release
assembly (#1) or rear quick release assembly (#2) and
tighten knob.
Note: The PRS-20/21's front axle fits standard 100mm
front dropout spacing. The rear axle has a threaded
axle extension (#4) that can be adjusted for 130mm or
135mm dropout spacing. When mounting bike by rear
dropouts, rest chain on axle extension.
4. Secure bottom bracket with retention strap and clip (#16).
5. Loosen knob (#5) at yoke and rotate bike to desired
working position. Tighten knob.
FOLDING FOR STORAGE
1. Pull hitch pin (#11) and fold horizontal beam tube.
Reinstall hitch pin.
2. Open clamping collar quick release (#20) and raise
collar to top of upright. Close quick release.
3. Fold legs (#24).
4. Loosen knob (#5) at yoke (#22) and lower upright.
Tighten knob.
For more information on the PRS-20 and PRS-21,
and for detailed bike repair instructions,
visit: www.parktool.com.