Hazard Warnings - ZIPPER MASCHINEN ZI-CRM40V-AKKU User Manual

 Only use the original charger to charge the battery. Using other chargers may cause
defects or cause a fire
 Always check that the mains voltage and frequency match the voltage / frequency
indicated on the charger's type-plate
BATTERY:
 Vapours may escape if used improperly or if the batteries are damaged. Supply fresh air
and consult a doctor if you have any complaints. The vapours can irritate the respiratory
system.
 DANGER OF FIRE! Never charge batteries in the vicinity of acids and highly flammable
materials.
 Only charge the battery in an ambient temperature between 0°C and +40°C. Allow to cool
down first after heavy load.
 DANGER OF EXPLOSION! Protect battery from heat and fire.
 Only use the battery in an ambient temperature between 0°C and +45°C.
 DANGER OF SHORT CIRCUIT! For disposal, transport or storage the battery must be
packed (plastic bag, box) or the contacts must be taped.
 Never open the battery
 The battery can be damaged by sharp objects such as a nail or screwdriver or by external
force. An internal short circuit may occur and the battery may burn, smoke, explode or
overheat
 Only charge the batteries with chargers recommended by the manufacturer. A charger
that is suitable for a particular type of battery creates a fire hazard when used with other
batteries

11.6 Hazard Warnings

Despite intended use, certain residual risks remain:
 Risk of injury due to noise:
Working for a long time can damage your hearing if you do not have a very good hearing protection.
 Risk of injury due to the working area:
Solid objects, stones, metal parts, or the like can be thrown out!
 Risk to the hands or fingers:
Do not grab in the cutting tool while it is rotating.
 Risk of injury due to pick up and roll up:
Wires and cords can be detected by the cutting tool and can damage the machine and can cause
injuries. Unplug battery and safety switch (if equipped) before removing the deposits!
 Risk of injury due to vibration:
The declared vibration emission value has been for a standardized test is measured and can be used to
compare one tool with another electric are.
The declared vibration emission value may also be used for a preliminary assessment of exposure.
 Rotating parts
If rotating parts (blades) are incorrectly mounted, this can lead to serious accidents.
Check before starting work, the cutting blade for tight fit.
Due to the design and construction of the machine, hazardous situations may occur which are identified
as follows in these operating instructions:
A safety instruction designed in this way indicates an imminently hazardous situation
which, if not avoided, will result in death or serious injury.
Such a safety instruction indicates a potentially hazardous situation which, if not
avoided, may result in serious injury or even death.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-CRM40V-AKKU
DANGER
WARNING
SAFETY
20