ZyXEL Communications NSA210 User Manual page 33

Table 2 NAS Starter Utility
LABEL
Host
IP
Status
NSA210 User's Guide
DESCRIPTION
This is the server name you configured for the NSA. If you have more
than one NSA in your network, it is recommended that you give each
one a unique name for identification purposes.
If you have several NSAs connected to your computer/network, hover
your mouse over the host name to view the details of each device. A
box pops up (see below) containing the details of each NSA. You can
identify the device you want to configure by checking the MAC address.
This is the current IP address of the NSA.
This shows whether the NSA is Uninitialized, Unreachable, Down,
Config Failed or Up.
• This shows Uninitialized when the hard disk does not have the
NSA firmware installed or the hard disk partitioning is not
compatible with the NSA.
• If the NAS Starter Utility fails to get a response or connect to the
NSA web interface for any reason, the NSA is considered
Unreachable. For example, the NSA may be unreachable if it's in a
different subnet to the NAS Starter Utility.
• If the NAS Starter Utility initially finds the NSA and then later the
NSA is turned off or changed to a different subnet, it will show
Down.
• If you use the NAS Starter Utility to change NSA settings, but the
NAS Starter Utility cannot apply the changes, it will show Config
Failed.
• When the NAS Starter Utility gets a response from an NSA and
connects to the NSA web interface using its IP address, it shows Up.
Config
Click this to change the NAS Starter Utility's network settings and
initialize and/or format the hard disk.
Admin
Click this to log into the web configurator. The default username is
'admin' and the password is '1234'.
Chapter 2 NAS Starter Utility
33