Advertisement
1.
Please be sure that the batteries in the transmitters are charged and if necessary
replace them. To open the battery case, take the microphone (25) and rotate
the upper grid (24) by unscrewing it anti-clockwise. Once you have completely
unscrewed it, pull the microphone's body (25) downside. To mount it again insert
it from the bottom minding that the display is in the correct position and then rotate
the upper grid. If you use bodypack transmitters just open the small cover(18).
Remember to plug the jack into the microphone's socket (19).
2.
Position correctly the receiving base, by keeping a distance of at least 1 mt from
the floor or walls. Connect it to mixers or amplifiers through the balanced XRL
sockets (3-4) or through the mixed socket with unbalanced Jack 6,3 mm (5) signal.
The models with one transmitter have only one XLR output.The output signal is
of microphone type. Make sure that the antennas (which are to be connect to 2-6
sockets) are raised in vertical position.
3.
Connect the adaptor to the back socket (1) and then to the 230V domestic power
source. Warning: don't connect the adaptor to the power socket before connecting
the jack: this could cause a spark and damage the unit.
4.
After turning on the other components of your audio system, press the ON/OFF
key (7) on the base and then the ON / OFF key (20-23) on the transmitter.
5.
If you are using a bodypack transmitter, the back clip will allow you to fasten it to
your belt for easy carriage.
6.
Adjust as you wish the receiver's volume through the controls (8- 14) on the base.
There are double controls to manage separately the two wireless microphones.
The displays show information on the signals received by the 2 wireless
microphones. The
7.
In order to work correctly, transmitter and receiver must operate on the same
frequency.
send it to the transmitter, turn it on and place the infrared sensor (22) at some cm
from the transmitting led (11) and then press once the key (9-13) to activate infrared
transmission. After a couple of seconds the process will be concluded and the
microphone will indicate the same frequency as the receiving base.
WARNING: the bodypack's infrared sensor is behind the battery case's cover (18).
Open the cover to carry out the frequency matching procedure.
8
Before arranging any connection make sure that the power
cord is unplugged from the mains. All connections must be
made with the device off.
single microphone models have just one volume control.
Usethe buttons (15-16) or (10-12) to choose the desired frequency. To
Advertisement
