Troubleshooting - bpr Dialflow Regulator Instructions For Use Manual

Applied Standards
AS 2473.3
AS 3840.1
BS EN ISO 10524-1
BS EN ISO 14971
BS EN ISO 15001
BS EN ISO 15002
BS EN ISO 15223-1
BS EN 13544-2+A1
BS 5682
7.

Troubleshooting

Fault
No gas flow
Internal/external leak
Insufficient gas flow
8. Parts and Spares List
Part Number
818-0040
818-0041
818-0043
Valves for compressed gas cylinders
Part 3: Outlet connections for medical gases (including pin-indexed yoke
connections)
Pressure regulators for use with medical gases
Part 1: Pressure regulators and pressure regulators with flow-metering
devices
Pressure regulators for use with medical gases. Pressure regulators and
pressure regulators with flow-metering devices
Medical devices. Application of risk management to medical devices
Anaesthetic and respiratory equipment. Compatibility with oxygen
Flow-metering devices for connection to terminal units of medical gas
pipeline systems
Medical devices. Symbols to be used with medical devices labels,
labelling and information to be supplied. General requirements
Respiratory therapy equipment. Tubing and connectors
Specification for probes (quick connectors) for use with medical gas
pipeline systems
Possible Cause
Gas cylinder turned off
Dial-Flow Regulator not
connected properly
Gas cylinder empty
Filter blocked
Flow selection dial set to '0'
Seal failure
Filter partially occluded
Supply pressure too low and/or
gas cylinder nearly empty
Description
Dial-Flow Regulator - O
Dial-Flow Regulator - O
Dial-Flow Regulator - O
Solution
Check gas supply
Check gas specific probe is correctly
connected
Replace gas cylinder
Service or repair is required
Select a positive flow rate
Service or repair is required
Service is required
Check gas supply and/or replace gas
cylinder
Range A - Pin Index/Barb
2
Range C - Pin Index/Barb
2
Range E - Pin Index/Barb
2