Advertisement
Available languages
Available languages
Parametrization of the luminaire
All parameters, like constant light control, run on times, fading times, etc. can be changed using remote
control. Caution: Parametrization is not possible for luminaires without sensor (LST)!
IR 6 remote control
Article number: 28000647
Target Group: end user
Questions about EPURIA-S
For questions about EPURIA-S Lighting Management, please contact:
Zumtobel Lighting GmbH
Schweizer Strasse 30
6850 DORNBIRN
ÖSTERREICH / AUSTRIA
For general information about our products, please refer to our website,
www.zumtobel.com or contact the respective contract partner. If you have any special
questions, please contact your sales partner.
EPURIA-S FAQ
►Motion sensor does not function
→ Dim value set too low, luminaire switches
off
→ Brightness in the room too high, luminaire
switches off
►Luminaire switches itself on
→ Lighting level in the room is below the
set brightness value
→ Motion sensor reacts to detected motion
in the room
→ Motion sensor reacts to a fast change of
heat in the room (for example, as well
as persons, printers, radiators etc. can
also be detected as motion)
3 EN
EPURIA-S Lighting Management
basicDIM ILD remote control
Article number: 28000257
Target group: electrician, facility
manager
DSI Smart Programmer
Article number: 28000843
Target group: electrician, facility
manager, sales force
►Luminaire does not switch on
→ Check voltage supply of the luminaire
→ Check mains adapter of the luminaire
→ Luminaire or EPURIA-S Lighting
Management defective
Recommendation: Contact Service
→
►Setting of the dim value
→ Do not influence or cover the light sensor
when setting the dim value
►Light sensor does not function
→
Automatic mode deactivated
00157562/P-/AS/02.2020
Advertisement
