Zumtobel EPURIA-S LST Operating Manual page 2

management
Operation via switch for luminaire version LST & SC
The operation of the luminaire is performed by a switch in the luminaire.
All sensor versions can be operated and parametrized using a remote control (see page 2)
For luminaires with an integrated basicDim wireless module operation is only possible via App.
Operation
Switch on luminaire
Switch off luminaire (standby)
Adjust illuminance manually
(dim)
Set current light level
Functions of EPURIA for luminaires with daylight and presence
detection
The functions of the EPURIA Lighting Management guarantee high comfort at the workplace and can
significantly reduce the energy consumption.
Constant light regulation
Motion detection
1 EN
EPURIA-S Lighting Management
Briefly press switch once
Briefly press switch once
Press and hold switch until the desired illuminance level is set. To change
the direction of the adjustment, release the switch, press again and keep
pressed.
Choose desired illuminance level – briefly press switch twice – luminaire
flashes for confirmation. After Standby / power failure (only if "Power-Up"
is turned ON – default) the luminaire switches back in to this set light level
The constant light control of the EPURIA Lighting Management
automatically adapts the lighting to the lighting conditions at the
workplace (sunshine, overcast sky, closed Venetian blinds). A
brightness sensor compares the illuminance on the work area with
an adjustable desired value for this. If illuminance is not sufficient,
the lacking light quantity is adjusted upwards. If there is too much
light, the luminaire is adjusted downwards. In doing so, the
adjustment is performed with a certain inertia to prevent too fast
and thus unpleasant change of the illuminance. A desired light
level (incl. OFF) can also be set manually. This level is maintained
as long as presence is detected. After 10 minutes of absence the
automatic mode is re-enabled.
The luminaire is switched on and off automatically using the
motion detection. A passive infra-red sensor (PIR) monitors
the detection range for this (diameter approx. 3.5 m). The
luminaire is switched on automatically as soon as any person
is located in the detection range. However, if the constant
light control registers illuminance above the individually
adjustable desired value, the luminaire remains in standby
mode. If no person is registered in the detection range within
an adjustable run-on time the luminaire automatically
switches to the standby mode.
00157562/P-/AS/02.2020