Operation Of Radio Gong; Connection Of The Transmitter With An Available Bell System - REV FUNKGONG VIVO Operating Instructions Manual

5. Operation of radio gong

remove the cover of the gong.
Type 04821: Insert 3 x 1.5V batteries into the Gong and 2 x 1.5V AAA batteries
into the transmitter.
Type 04281r2: Insert 3 x 1.5V batteries into the Gong and 1x 3V Cr2032 bat-
teries into the transmitter.
Take care to ensure the polarity is correct. Match the house code of the gong and
the transmitter, i.e. both rotary switches should point to the same number.
This product would not perform normally under a strong electro static environ-
ment, it may need manual reset to normal operation.
receiver

6. Connection of the transmitter with an available bell system

(Only transmitter type 04281R2)
An available bell arrangement can be extended with this radio-controlled gong.
The connection clips B & C (bell connection) must be connected with an approx.
50cm long dual-core wire (bell wire) directly to the connections in the available
bell signal system or gong. The distance between bell and transmitter should be
between approx. 30 to 40cm.
The cable must be lead out of the displayed section of the inner casing.
14
Transmitter Type 04281r2
existing bell signal
system / gong
existing bell
button
Transformer
Transmitter
C
