Table of Contents
Advertisement
CAUTION
1.
Pay attention to the polarity of the plugs. The orange signal line must always be on the top and the brown on
the bottom.
2.
Check all the connectors and make sure that all of them are firmly connected to the sockets.
3.
Please refer to the instructions of your transmitter for setting up the 3-position switch for flight mode control,
and the knob (or slider) for remote master gain control.
4.
You have to restart the gyro after you change the receiver type to make the new setting take effect.
4.5.
Using the A3S3 on a nitro/gas plane is similar to electric planes, follow the below illustration to complete connection
between the gyro and receiver.
support@hobbyeagle.com
11
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the A3 SUPER 3 and is the answer not in the manual?