Advertisement
Quick Links
DALI
DALI
Switch-Dim
RF Sensor Antenna
Model: SAM8/RC11
Detection range (DxH): 12 x 6m
RF Sensor Antenna (with rotary switch for fast grouping)
Model: SAM11
Detection range (DxH): 12 x 6m
HIGHLIGHTS
• Standby power < 0.5W
• Automatic output reduction 80%--60%--40%--20%
against overheat
• DALI default feedback
• Flicker-free dimming from 100%~30%
• In compliance with DALI 2 standard.
• DALI, Switch-Dim and 1-10V dimmable
LED CURRENT SELECTION
The current can be easily configured by choosing the correct
combination of the DIP switches (see table below):
HYTRONIK INDUSTRIAL LIMITED
Room D, 10/f, Tower A, Billion Center, 1 wang Kwong Road,
Kowloon Bay, Kowloon, Hongkong
T: 00852-35197525
F: 00852-30116936
E: info@hytronik.com
INSTRUCTION MANUAL FOR 50W HEX DRIVE
MODEL NO.: HED1050L + SAM8/RC11 (SAM11)
379.5
390
RF antenna
Antenna module
Buzzer
Cable entry
Installation hole
RF antenna
Antenna module
Rotary switch
mA
1
2
3
4
5
600mA
575mA
550mA
525mA
500mA
475mA
450mA
425mA
400mA
375mA
350mA
325mA
300mA
275mA
250mA
225mA
CHINA FACTORY
3rd Floor, block C, complex building, 155#, Bai'gang road south,
Bai'gang village, Xiao Jin Kou town, Huicheng district, Huizhou 516023
Tel:86-752-2772020
E: info@hytronik.com
LED indication
Infrared remote receiver
Daylight sensor
Buzzer
Daylight sensor
Installation hole
Infrared remote receiver
LED indication
RF Grouping via Rotary Switch (for SAM11)
15 channels are available for fast grouping via rotary switch on
the RF sensor antenna, simply selecting the same channel on
each unit, the grouping is automatically completed.
Noted:channel "0" is not for fast grouping, and sensors can only
be grouped by remote control.
F:86-752-2777877
W:www.hytronik.com
RJ12 sensor antenna
-
1-10V
+
-
LED
+
DIP switch (for LED
current seclection)
32.5
43.3
52.5
57.5
63.6
71.5
Use a screwdriver
to point the arrow to
the same channel
on each RF sensor
antenna.
Advertisement
Related Manuals for Hytronik HED1050L
Summary of Contents for Hytronik HED1050L
- Page 1 Bai'gang village, Xiao Jin Kou town, Huicheng district, Huizhou 516023 T: 00852-35197525 F: 00852-30116936 Tel:86-752-2772020 F:86-752-2777877 E: info@hytronik.com E: info@hytronik.com W:www.hytronik.com INSTRUCTION MANUAL FOR 50W HEX DRIVE MODEL NO.: HED1050L + SAM8/RC11 (SAM11) DALI RJ12 sensor antenna DALI 1-10V Switch-Dim DIP switch (for LED current seclection) 379.5...
- Page 2 Daylight Monitoring Function Hytronik specially designed this function in software for deep energy-saving purpose. A built-in daylight sensor is designed to provide “smart photocell” setting when the natural light goes below the threshold setting. The fixture will also switch off as the natural light returns.
- Page 3 Note: when manually push on the master via push switch, it can send a “on” signal to all slaves in the same group. The slaves will turn on when ambient light is below its daylight threshold preset. * Long push (>1s): dim up/down the hold-time brightness between 10% and 100%. Note: if end-user do not want this manual override function, just leave the “push”...
- Page 4 Dual tech & RF mode [ zone 1. HF, PIR, HF+PIR, HF/PIR are disabled. 2. For RF grouping, please see next page. RF grouping Short press “Learn Beeper is on for 3min /Erase” button Short press “Learn/Erase” button on RC to activate pairing mode, and the receiver unit will beep once every second for 3min.
Need help?
Do you have a question about the HED1050L and is the answer not in the manual?
Questions and answers