Eastern Tabletop 2890 Instruction Manual page 12

4-2. Tighten the gas steel pipe nut and gas inlet thread.
4-3. Put the burner with steel pipe onto the post.
4-4. Fix the burner base to the post by 4 pcs M6 x 10 mm bolts.
STEP 5
5-1. Check whether the connection of vertical post and burner are assembled as
instruction, and all bolts and nuts are tightened.
5-2. Put the flat washer onto the top of each burner/reflector support bolts
(M8 thread).
STEP 6
6-1. Put the reflector on top of the burner and passing through 3 pcs
burner/reflector support bolts.
6-2. Fit washers into each support bolt and tighten each by M8 castle nut.
STEP 7
7-1. Bring up the tank housing and rest it on the post plate.
7-2. Fit the gas regulator rubber hose with the end thread of inlet gas steel pipe
and tighten the nut.
7-3. Connect the regulator with the LPG gas tank in counter-clockwise direction
and tighten it by adjustable wrench.
7-4. Put the LPG gas tank into stand.
-9-
STEP 4
Bolts
STEP 5
Reflector flat
washer
STEP 6
Nut
STEP 7
7.1 7.2
Gas Tank