Eastern Tabletop 2890 Instruction Manual page 11

Assembly Procedures
STEP 1
1-1. Put the three pcs post brackets on each position on the base
as shown in the picture.
1-2. Use 3 pcs M8 x 16 mm bolts to join the post brackets and
stand.
STEP 2
2-1. Put the post onto the top of 3 pcs post brackets.
2-2. Use 6 pcs M6 x 35 mm bolts and nuts to connect the post to the 3pcs post
brackets. Tighten the bolts and nuts.
STEP 3
3.1. Put the tank housing through the post.
STEP 4
4-1. Fit the gas steel pipe nut into the burner gas inlet connector.
4-1-1. Secure the reflector support bolts on the flame screen cap with 3
pcs 60 mm length pins & 3 pcs Ø8 mm washers.
4-1-2. Connect the pins & washers to the flame screen.
4-1-3. Tighten the pins.
-8-
STEP 1
Square metal
support
Stand
Bolt
STEP 2
Post
Nut
Bolt
STEP 3
Tank
housing
STEP 4-1