Advertisement
MAINTENANCE AND CLEANING
WARNING!
Before maintenance or cleaning is carried out, the cooker
hood should be disconnected from the main power supply.
Ensure the cooker hood is switched off at the wall socket
and the plug removed.
WARNING!
External surfaces are susceptible to scratches and
abrasions, so please follow the cleaning instructions to
ensure the best possible result is achieved without damage.
Stainless steel surface
These instructions must be followed to avoid a fire risk.
Clean stainless steel surfaces using non-abrasive cleaning
products that are specifically for use on stainless steel. To
ensure best results also use an even pressure and follow
the grain of the stainless steel. Use of a soft cloth reduces
the risk of scratching. If the cloth is wet ensure that a dry
soft cloth is used to wipe down the surface again and then
apply a satinless steel protector spray to reduce the risk
of any surface rust appearing.
Cleaning grease filters
The filters can be cleaned by hand or dishwasher. After
cleaning ensure the filters are completely dry before
refitting. Grease filters must be removed every four weeks
(maxumum) for cleaning to reduce the risk of fire.
•
By hand - Soak in warm water and some washing up
liquid. For stubborn grease stains use a soft nylon
brush to help remove those stains.
•
In a dishwasher - Ensure that placement of the
filters is made so as to not impede the function of
the dishwasher spray arm. Washing the filters in
a dishwasher may cause discolouration over time
although it will not effect their performance. Filters
should be washed seperately to crockery and other
kitchen utensils.
Removing filters
1. Lift the filter.
10
MAINTENANCE AND CLEANING
2. Pull down the filter lock level and then pull the filter
assembly down and out of the hood.
Unscrew all the 4 screws on lateral sides, then open
the inner filter for cleaning.
Do not use the cooker hood without filters installed.
Do not clean the canopy cooker hood with water
using a hose or high pressure cleaner.
Use both hands for removing and re-fiting the fiters
to avoid accidentally dropping the fiters and causing
damage to your cooktop or kitchen surfaces.
Replacing the LED lamps
If the LED lamps need replacing, they must be replaced
by lamps as stated in the technical specification:
Lamp
Power (W)
3
Socket
-
Voltage
12VDC
Dimension (mm)
70 x 20
ILCOS Code
DSR-3-S-70
To purchase replacement lamps, contact an authorised
Electrolux service centre.
MAINTENANCE / TROUBLESHOOTING
To remove the lamp, ensure the power to the hood has
been disconnected. Then use a screwdriver to push the
LED lamp assembly out of the hood body.
Unplug the old lamp and then connect the new lamp.
Push the lamp assembly into its location, without
trapping the wiring.
Troubleshooting
PROBLEM
REMEDY
The cooker hood will not start
Check that cooker hood is connected to an electrical supply.
Check that a fan speed has been selected.
The cooker hood is not working
Check that fan speed is high enough.
Check that the grease filters are clean.
Check that the kitchen is adequately vented to allow entry of fresh air.
Check that ducting and outlets are not blocked.
The cooker hood has swiched off during operation
The safety device may tripped - turn off the cooking appliance and wait
for the device to reset. If the hood is installed below the heights indicated
in the installation instructions, the motor will cut out frequently which
will damage the cooker hood.
If you have completed all of the above checks and are still experiencing
difficulty, please contact your local Electrolux Service Centre.
11
TROUBLESHOOTING
Advertisement
