Download Print this page

Beef Eater BRC214SA Assembly And Operating Instructions Manual page 4

Advertisement

COOKER HOOD INSTALLATION
1.
Using a spirit level mark a vertical centre line on the
wall where the cooker hood is to be positioned, and
a horizontal line at the hood base position.
NOTE: See table below for the minimum and maximum
height of the underside of cooker hood.
COOKER
INSTALL
MIN HEIGHT*
MAX HEIGHT*
TYPE
CLASS
(mm)
Electric hob
Indoor
600
Gas hob
Indoor
650
Gas BBQ**
Indoor
1350
Gas BBQ**
Quasi indoor
1200
Gas BBQ**
Outdoor
1200
160
160
21.5
Ceiling
VIEW A
286
446
575
680
65
Centreline of cooking hood
Installation
height
6
COOKER HOOD INSTALLATION
* If the instructions of the cooker specifies a greater
distance than the minimum height stated, then that
shall be the minimum height for the installation
** Installation height as specified in AS/NZS5601.1
and/or the local authority Regulations
2.
Mark the location for flue cover wall mouting brackets
and cooker hood mounting points and anti-tilt fixing
(mm)
points above the hood base using the hood base as
the reference points.
1200
1200
1350
1350
1350
Installation wall
160
587
VIEW A
Rangehood mounting points
Anti-tilt fixing points
WARNING!
Failure to install the
screws or fixing device
in accordance with these
instructions may result
in electrical hazards.
COOKER HOOD INSTALLATION
3.
Install flue cover wall mounting brackets with suitable
fixings. Install suitable screws for cooker hood
mounting points (to support a total weight of 55kg)
to the wall as marked.
55
287
4.
Remove protective plastic film, if present, from the
hood body and hang on the wall bracket. Install the
two anti-tilt fasteners.
WARNING!
Heavy product (51kg) – use a mechanical lifter, or at least
two persons.
5.
Use cable ties or suitable duct tape to secure flexible
pipe to the duct outlet.
ø 200mm
6.
The cooker hood can control the gas supply by
controlling the solenoid valve. Unscrew those 4
screws to open the cover of connection box.
7.
Connect the wire as following picture show, then
close the box cover and fix it with screws.
Power supply
Brown
for solenoid
Grey
Connect to gas solenoid
COOKER HOOD INSTALLATION
7

Advertisement

loading