Advertisement
LOCATION
The water dispenser should be placed on a firm, even foundation to
minimize noise and vibration.
Do not place the dispenser in direct sunlight or near other heat producing
appliances.
To avoid accidental water damage, locate it away from furniture or other
appliances.
The unit must be placed within reach of a properly-rated grounded socket.
Never place any obstacles around the air inlet or outlet of the unit.
Allow a minimum 8 inch clearance on all sides for efficient operation.
This unit should work in temperatures ranging from 50-109
ASSEMBLY
1.
Remove the drip tray from the door and place the grid on top.
2.
Snap the drip tray and grid assembly into the door.
INSTALLATION
1.
Open the water dispenser door.
2.
Place the probe assembly on the probe hanger.
3.
Remove plastic cap from top of the bottle.
4.
Clean outside of the bottle with a cloth.
5.
Place probe into the bottle.
6.
Slide collar down until it clicks into place.
7.
Push the head down until the tubes hit the bottom of
the bottle.
8.
Slide the bottle into the cabinet and close the door.
9.
Plug the power cord into a properly grounded outlet.
10. The pump will begin to move water from the bottle
to the hot and cold water tanks. This process will
take up to 12 minutes in order to fill both tanks for
the first time. During this time, the pump will run
continuously.
11. This unit will not dispense hot or cold water until the
switches are active. To activate, push the top side of the power switches.
7
A Name You Can Trust
°
Fahrenheit.
Advertisement
