The Control Panel - Zanussi FLS 1084 Instruction Booklet

The Control Panel

Temp.
Whites A B
95º
Fast coloureds C
60º
D
Non-fast coloureds 40º
J
Synthetics 50º
Mixed fabrics K 40º
Wool L
1 Programme guide
2 Half load button
Select this button to reduce water consumption on the
rinse cycle when washing a smaller load of cottons or
linens (maximum load size = 2.25 kg).
The machine will perform 3 rinses instead of 4.
3 RINSE HOLD button
Press this button to make the machine stop with water in
the drum after the synthetic or delicate wash cycles.
This prevents any creasing which may take place if the
clothes are left damp in the drum. When it is convenient
for you to empty the machine, simply press this button
again so that the machine can proceed to drain and short
spin, or turn the dial to the drain programme "R".
If this button is not activated, the washing programmes
will end with a short spin.
Do not press this button for woollens: wool items should
be gently spun.
4 Spin Speed Reduction button
By depressing this button the spin speed will be reduced
as follows:
- cotton and linen: from 1000 to 500 rpm
- synthetics, delicates and wool: from 600 to 400 rpm.
Temp.
Delicates M 40º
F
Quick wash 40º
N
Worn once 30º
G
Rinses P
Spin H Q
Drain R
1 2 3 4 5
5 Extra Rinse button
By depressing this button the machine will perform the
rinses with high water level.
This is recommended for people who are allergic to
detergents and in areas where the water is very soft.
6 Mains-on light
This light illuminates when the machine starts working
and goes out at the end of the programme.
7 Programme selector dial/ON/OFF
switch
With the programme selector dial you choose the
desired washing programme. Turn it clockwise.
To start the programme, pull the dial outwards.
To switch the machine off, push the dial inwards.
Before setting the dial to any position the machine must
be switched off by depressing the dial.
6
6 7