Laser 5626 Instructions

Instructions
1. First, park the car in accordance with the best safety practice, but DO
NOT apply the handbrake.
2. Next, jack up the car and remove the road wheel or wheels to expose
the brake calipers on which you are going to work.
3. Remove one or both of the caliper retaining fasteners and either pivot
the caliper away from the brake disc or detach it completely.
Note: Take great care at all times not to damage or snag the brake
hose as this may subsequently make the vehicle unsafe.
DO NOT allow the calliper to hang free by its flexible hose.
4. Remove the worn brake pads after first disconnecting the wear warning
wires if these are fitted.
5. Now select the appropriate drive key to suit the position. The drive key
should be as near as possible to the same diameter as the piston.
6. Fit the drive key to the force screw. To make this easier, the force screw
is magnetic and has two pins to engage the drive key positively.
Note: Some pistons need to be rewound under pressure. For this
purpose, use the reaction plate (Pic.1)
Lubricate the force screw with a few drops of oil before using it.
7. Slip the reaction plate over one arm of the T-bar on the force screw and
manoeuvre it on to the reaction body so that it rests against the flange
at the bottom of the body.
8. Now fit the reaction plate into the caliper fork (Pic.1) and tighten the
force screw by turning the T-bar clockwise until the piston is fully
rewound into the bore.
9. Finally, loosen the force screw by turning the T-bar anti-clockwise until
you can remove the force screw and reaction plate from the caliper.
10.Fit new brake pads, service the caliper and reassemble.
Guarantee
If this product fails through faulty materials or workmanship, contact
our service department direct on: +44 (0) 1926 818186. Normal wear
and tear are excluded as are consumable items and abuse.
Distributed by The Tool Connection Ltd
Kineton Road, Southam, Warwickshire CV47 0DR
T +44 (0) 1926 815000 F +44 (0) 1926 815888
info@toolconnection.co.uk www.toolconnection.co.uk
Brake Caliper Rewind
Tool Kit
Instructions
Brake caliper rewind tool kit with a unique force
screw handling right and left applications.
• Manufactured from
selected steel and
packed in a blow case
• Complete with 15
adaptors, 3/8"D force
screw, reaction plate
and 3/8"D adaptor
• With unique left and right
handed force screw
• Designed for popular
European cars
www.lasertools.co.uk
5626