EuroLite LED TMH-75 User Manual page 27

DMX ADDRESS
RUN MODE
MOVING INVERT
MOVING DEGREE
DEFAULT
SPECIAL
DMX address setting
001-512
With this function, you can adjust the desired DMX-address via the
Control Board.
DMX control
DMX512
DMX controlled mode when there is DMX signal.
Sound control
SOUND
Sound controlled mode when there is no DMX signal.
AUTO1
Automatic program mode when there is no DMX signal
With this function, you can run the internal program.
This mode allows a single unit to run to a factor y installed program
AUTO2
in one of three speeds.
To set the fixture to auto mode Slow, select
fixture to auto mode Medium, select
fixture to auto mode Slow, select
AUTO3
NORMAL
PAN
INVERT
NORMAL
TILT
INVERT
540°
PAN
360°
180°
270°
TILT
180°
90°
LOAD
SETTINGS
OFF
DISPLAY
OFF
ON
RESET
SOFTWARE
VERS
27/36
"AUTO1", to set the
"AUTO2" and to set the
"AUTO3"
.
PAN Reverse
With this function you can reverse the PAN
movement.
TILT Reverse
With this function you can reverse the TILT
movement.
Set PAN angle
With this function you can choose the PAN angle
between 540°, 360° and 180°.
Set TILT angle
With this function you can choose the TILT angle
between 270°, 180° and 90°.
Restore factory settings
With this function you can restore the factor y
settings of the device. All settings will be set back
to the default values.
Display close time
With this function you can shut off the display
after 60 seconds or you can choose no display
shut off.
Reset Function
With this function you can reset the device via
the Control Board.
Software version
With this function you can display the software
version of the device.
00124762, Version 1.0