Start-Stop System - Seat Arona Owner's Manual

and needs to be started manually, the start
button flashes to indicate this situation.

Start-Stop system*

Control lamps
 It lights up
The Start-Stop system is available, the automatic en-
gine shutdown is active.
 It lights up
The Start-Stop system is not available or has been
disconnected.
Instructions for the driver on the instru-
ment panel display
Start-Stop system deactivated.
Start the engine manually
This indication for the driver shows that the
Start-Stop system cannot start the engine
again.
Start-Stop system: Fault! Function
not available
1) Only in vehicles with Keyless Access.
Start and driving
There is a fault in the Start-Stop system. Take
the vehicle to a workshop to have the fault re-
paired.
Description and operation
The Start-Stop system helps you to save fuel
and reduce CO emissions.
2
In Start-Stop mode, the engine will automati-
cally switch off when the vehicle stops or is
stopping. The ignition remains switched on.
The engine automatically switches back on
when required.
In this scenario, the light of the
1)
button stays lit .
When the ignition is switched on, the Start-
Stop function is automatically activated.
Further information about the Start-Stop sys-
tem can be found in the Easy Connect sys-
tem: press the button    > View >
.
Vehicle status
Vehicles with a manual gearbox
When the vehicle or when it is stopped, put
●
it into neutral and release the clutch pedal.
The engine will switch off. The warning lamp
will light up. The engine can be stopped

before stopping completely (approximately 7
km/h).
When the clutch pedal is pressed the en-
●
gine will start up again. The warning lamp will
switch off.
Vehicles with an automatic gearbox
Brake until the vehicle stops and keep your
●
foot on the brake pedal. The engine will
switch off. The warning lamp
the display. The engine can be stopped be-
fore stopping completely (approximately 7 or
2 km/h depending on the vehicle's gearbox).
When you take your foot off the brake ped-
●
al the engine will start up again. The warning
  
lamp will switch off.
Basic requirements for the Start-Stop
mode
The driver door must be closed.
●
The driver's seat belt must be fastened.
●
The bonnet must be closed.
●
The engine has reached operating temper-
●
ature.
The reverse gear must not be engaged.
●
The vehicle must not be on a very steep
●
slope.
will appear in

»
195