User Guide (English) Introduction Thank you for purchasing the TS3 Series loudspeaker. At Alto Professional, performance and reliability mean as much to us as they do to you. That’s why we design our equipment with only one thing in mind—to make your performance the best it can be.
Important Safety Precautions Please note: Alto Professional and inMusic are not responsible for the use of its products or the misuse of this information for any purpose. Alto Professional and inMusic are not responsible for the misuse of its products caused by avoiding compliance with inspection and maintenance procedures.
Setup Volume Control The TS3 Series loudspeaker accepts both line-level and mic-level audio sources. Before connecting your audio source, turn the Volume knob to the minimum position (fully counter-clockwise). Line-Level Audio Source When using an audio source such as a mixer, CD/MP3 player or audio preamp, follow the outer/Line level band indicator.
Page 5
1/4” (6.35 mm) TRS cables. Do not turn the Volume knobs past the 0 dB position. Tip: To send the same mix to both TS3 Series loudspeakers, connect both channels of your DJ mixer, controller, etc. to the Input 1 and Input 2 of one loudspeaker, and then connect that loudspeaker’s Mix Out to the Input 1 of the other loudspeaker.
Page 6
Example C: Two Loudspeakers + Two Extensions Connect each of your mixer’s main outputs to Input 1 on each TS3 loudspeaker. Connect the Mix Out of each TS3 loudspeaker to an input of each extension loudspeaker. Do not turn any of the Volume knobs past the 0 dB position.
Features Rear Panel AC Input: Use the included power cable to connect this input to a power outlet. Make sure the Power Switch is set to off when connecting or disconnecting the cable. Fuse: If the unit’s fuse is broken, lift this tab to replace the fuse.