Kärcher Duo Smart Manual page 12

 Regularly check the filter at the water in-
let for damage. Particles in the water
which enter the device through a dam-
aged filter will prevent the valve from
opening and closing properly.
 Replace the damaged water filter imme-
diately.
 Check the device for leaks and ensure
that the valves open and close reliably if
the device has been shut down for a
long period of time, and always at least
once a month.
 Do not pull on connected hoses.
 Observe wall and surface requirements
before wall mounting.
 When mounting on the wall, check the
load capacity of the wall. Mount the de-
vice securely on the wall.
 The device must be accessible at all
times. Do not mount the device in inac-
cessible places or higher than 2 meters.
 Do not install the watering valve near
heat sources and protect it against frost
(permitted ambient temperature 5 °C to
40 °C).
 Only use batteries approved for your wa-
tering valve. You can find information
about the required battery type in the op-
erating instructions for your device.
 Do not use rechargeable batteries.
 Do not install the watering valve in loca-
tions where condensation can form.
 Do not operate the watering valve near
devices that are connected to power.
 Do not start up a device that is not func-
tioning correctly.
Gateway safety instructions
 Never open the device or the plug-in
power supply.
 Route the connecting cable such that
no-one can tread on it or trip over it.
 Only operate the device with the plug-in
power supply provided or with an appro-
priate replacement (order number
6.745-102.0).
 Always connect the plug-in power sup-
ply to a mains socket that is accessible
at all times and corresponds to the val-
ues indicated on the type plate.
12
 Never immerse the device in liquids.
 Never touch the plug-in power supply
with wet hands.
 Only operate the device in dry indoor
rooms.
 Place the device on a stable and non-
slip surface.
 Set up the device away from heat sourc-
es and direct sunlight.
 Do not place the device on heat-sensi-
tive surfaces.
 Observe wall and surface requirements
before wall mounting.
 When mounting on the wall, check the
load capacity of the wall. Mount the de-
vice securely on the wall.
 The device must be accessible at all
times. Do not mount the device in inac-
cessible places such as behind panels,
inside furniture or higher than 2 meters.
 Do not operate the device near other
electrical devices. Especially not in the
vicinity of other radio equipment.
 Only dry-clean the device, with a duster,
for example.
 Do not pull on the cable.
Wireless standards
The devices use the following wireless
standards:
 ZigBee (IEEE 802.15.4)
 WLAN (IEEE 802.11)
Device Type
Gateway SRD
Water SRD
Controller
Duo Smart
Alfred Kärcher GmbH & Co. KG hereby de-
clares that the radio system type Gateway /
watering valve (Water Controller Duo
Smart) complies with the Guideline 2014/
53/EC. The complete text of the EC Decla-
ration of Conformity is available at the fol-
lowing Internet address:
www.kaercher.com
English
Frequen- Power,
cy, MHz max. ERP
2400 - 110 mW
2483,5
2412 - 10 mW
2472