Sharp AN-SS1 Operation Manual page 11

Listening to Bluetooth enabled devices (continued)
This unit can easily be paired / connected with the help of voice prompts.
If voice prompt says that the battery is insufficient, then you are advised
to recharge the battery before proceeding to pair and connect.
In case pairing is not completed within three minutes for various reasons,
the power automatically turns off, with power switch still in ON position.
To turn the device on, slide the Power Switch to OFF position and then
back to ON position.
Quick Connection
1
Turn on the unit by sliding the power switch towards the ON position.
The unit switches to Search Mode and the Blue LED turns on.
2
Perform pairing procedure on the source device to detect this unit.
"AN-SS1 SHARP" will appear in the detected devices list (if available)
in the source device. (Refer to the source device operating manual
for details).
Notes:
z Place the devices to be paired within 1 meter (3 feet) of each other
when pairing.
z Some source devices are unable to display lists of detected devices.
To pair this unit with the source device, refer to the source device
operating manual for details.
3
Select "AN-SS1 SHARP" from the source list. If Passcode* is required,
enter "0000". When connection is complete, it is announced by voice
prompt.
* Passcode may be called PIN Code, Passkey, PIN number or Password.
EN-10