EESiFlo 6000 Series Installation

Simplified Installation of the 4-20mA Output
on the EESiFlo 6000 Series Ultrasonic Flow Meter
Note:
Setting up the 4-20 mA output on the 6000 Series Ultrasonic Flow Meter involves four distinct steps.
1. Define the Pipe and Medium Parameters (PAR on the main menu)
2. Setting up the 4 to 20 mA output (SF on the main menu)
3. Selecting the Output Options (OPT on the main menu)
4. Enter the Measure Mode (MEA on the main menu)
Defining the Pipe and Medium Parameters >PAR<
1) Start by turning the instrument
2) Plug the Transducers into the receptacle marked
automatically detect which transducers are installed by displaying that information on the LCD.
3) Using the 4 or 6 keys scroll to
ENTER
4) Press again to view
Channel B.
5) Enter the pipes
6) Or, if the pipes diameter is not known, simply enter 0.00 in the diameter and the 6725 will
prompt you to enter the
Wall Thickness
7) Next, enter
Pipe Material
8) Select a
list.
219 East Main Street
Mechanicsburg, PA
USA, 17055
Toll Free: 866-337-4356
Fax: (717) 697-2122
The 4 to 20 mA outputs on FlowRental.com rental meters are
"ACTIVE" OUTPUTS
ON
by pressing the
PAR
(parameters) on the main menu and press
Channel A Parameters
Outer Diameter
then press
Pipe Circumference.
by using the 2 and 8 keys to scroll up and down through the available
ON/C
button
Channel A
(or B) and the 6000 SERIES will
or use the 2 and 8 keys to select
ENTER.
ENTER
.
Page 1 of 4