Advertisement
Firmware upgrade
Announcements
1.
Do not touch the gimbal during the initialization after power on, Keep the gimbal in quietude
2.
Do not use BEC for the gimbal power, use 3~6S Lipo battery
3.
Strongly recommend using 12mm tube to mount the gimbal
4.
Make sure the center of gravity of the gimbal is correct before using.
固件不可随意升级，升级前一定要先阅读说明，不合适的固件烧录会导致云台无法工作
5.
Disclaimer
X-CAM A10-3H gimbals are covered by one year limited warranty. Please do not disassemble or modify mechanical structure
in the warranty period. The customized program of X140B control module is based on A10-3H structure and motors, and all
debugging has been completed in factory. Any direct or indirect damages caused by a user during use or damage will not be
covered by our warranty, and X-CAM will not compensate the loss and the corresponding liability.
X-CAM does not take any responsibility toward any damage or loss in using A10-3H gimbal.
产品保修登记： http://warranty.x-camtech.com/cgi-bin/XCamWarranty.dll
1.
Turn off the Gimbal
2.
Uses the USB cable to connect with your PC, Normally the windows can find the
driver automatically, you will find the PORT number in the device manager.
3.
Select the COM port number
4.
Open the firmware file ( *.bin )
5.
Click "Load and Connect" button
6.
Turn on the Gimbal, it will upgrade the firmware automatically
Notice: Please do not touch anything and keep the power on during the upgrade, if
the upgrade is break please back to STEP 1 and try again, normally it could be fix
automatically. It will beep 4 times after upgrade and the system will be restarted.
Advertisement
