Advertisement
Quick Links
X-CAM A22-2H for SONY NEX5 Series 2 Axis User Manual
X-CAM A22-2H has been finished with all the adjustments before launch the market, READY TO RUN.
Parameters
Weight: 580g(withoutCamera&Lens) Stabilizationfrequency: 5200Hz
InputVoltage: 11.1v~22.2v(3S~6SLipo) Tilttravel: +-90degree;Rollingtravel: +-45degree
Built-inHDMItoAVConverter，Supportsremoteinfraredrayshutter
AutoPilotSystemsupportingisnotrequired
SupportsLens： 16mmprimeLens;16-50Lens;16mm+0.75wide-angleLens
Accessories
Connection Instructions
●
1xX-CAMA22-2HGimbalFrame
●
1xX-CAMA22-2HController
●
1xUSBCable
●
1xPPMCable
●
15xDampingballs
●
1xCameraScrew
●
1xHDMItoAVConverter
Advertisement
Summary of Contents for X-cam A22-2H
- Page 1 X-CAM A22-2H for SONY NEX5 Series 2 Axis User Manual X-CAM A22-2H has been finished with all the adjustments before launch the market, READY TO RUN. Parameters Weight: 580g(withoutCamera&Lens) Stabilizationfrequency: 5200Hz InputVoltage: 11.1v~22.2v(3S~6SLipo) Tilttravel: +-90degree;Rollingtravel: +-45degree Built-inHDMItoAVConverter，Supportsremoteinfraredrayshutter AutoPilotSystemsupportingisnotrequired SupportsLens： 16mmprimeLens;16-50Lens;16mm+0.75wide-angleLens Accessories ●...
- Page 2 Manager Launch the X-CAM Gimbal Stabilization Module Assistant , choose the correct port number and click CONNECT Gain There are 2 gains, Position Gain and Acceleration Gain Pos.
- Page 3 Gimbal Control The Gimbal provides 2 ways to control the TILT, Linear Mode or Tracking Mode Linear Mode: Push the TILT stick to high or low for moving the camera mount to up or down until the stick back to midpoint Tracking Mode: Push the TILT stick to high or low, the camera mount will follow the stick position. Push speed: Setup the camera mount moving speed, high value set high speed;...
- Page 4 Do not use BEC for the gimbal power, use 3~6S Lipo battery Strongly recommend using 12mm tube to mount the gimbal Make sure the center of gravity of the gimbal is correct before using. 固件不可随意升级，升级前一定要先阅读说明，不合适的固件烧录会导致云台无法工作 Disclaimer X-CAM A10-3H gimbals are covered by one year limited warranty. Please do not disassemble or modify mechanical structure in the warranty period. The customized program of X140B control module is based on A10-3H structure and motors, and all debugging has been completed in factory. Any direct or indirect damages caused by a user during use or damage will not be covered by our warranty, and X-CAM will not compensate the loss and the corresponding liability. ...