Advertisement
IR Remote
Operation
Note: For best operation, point the IR remote towards
the IR Receiver (towards power adapter).
Turn on the Indoor/Outdoor LED Light Strip by
1
pushing the ON button on the remote control.
(It will turn on into the last used lighting mode.)
Select the desired color or effect by pushing
2
the corresponding button on the remote control.
Set the desired brightness using the buttons to
3
increase/decrease the intensity of color.
Push the OFF button to turn off the Light Strip.
4
Note: You can use this Light Strip with a timer outlet or smart
plug as it will power on into the last used lighting mode.
Changing the remote control battery:
Note: The battery for the remote control has already been
installed. Remove the battery pull tab to operate.
The battery compartment is located on the narrow
1
side of the remote control.
Remove the empty battery and insert a 3V battery, type
2
CR2025, with the positive terminal pointing upwards.
Place the battery compartment back in the remote
3
control so it locks in place.
Advertisement
