Advertisement
Get Started
Determine where you will install the Indoor/Outdoor
1
LED Light Strip. Make sure the location is close
enough to a power source for the cord to reach
without becoming a tripping hazard.
Using the included mounting clips and screws, mount
2
the Light Strip in the desired location. For best results
place one clip approximately every 20", or 5 scissors
marks, to secure the entire light strip evenly.
Note: Move some mounting clips closer to corners to better
secure the strip around turns, use fewer on straight areas.
Once installed, connect the power adapter to a powered
3
outlet. (Outdoors this must be a GFCI protected outlet.)
Remove the protective tab from the battery compartment
4
of the remote. You are now ready to use your product.
x5 (20")
TIP: If the power adapter doesn't reach to the
ground from the outlet, use the keyhole hanger
and a screw or nail to hang it.
Advertisement
