Rack Mounting; Cable Connections; Audio Connections - Behringer EURORACK UB1622FX-PRO User Manual

EURORACK UB1622FX
6. INSTALLATION

6.1 Rack mounting

The packaging of your mixing console contains two 19" rack
mounts for installation on the side panels of the console.
Before you can attach the rack mounts to the mixing console,
you need to remove the screws holding the left and right side
panels. Then, use these screws to fasten the two rack mounts,
each specifically to one side. With the rack mounts installed, you
can mount the mixing console in a commercially available 19"
rack. Be sure to allow for proper air flow around the unit, and do
not place the mixing console close to radiators or power amps,
so as to avoid overheating.
+

6.2 Cable connections

You will need a large number of cables for the various
connections of the console. The illustrations below show the
wiring of these cables. Be sure to use only high-grade cables.
Fig. 6.1: Foot switch connector
Please use commercial RCA cables to wire the CD/TAPE inputs
and outputs.
You can, of course, also connect unbalanced devices to the
balanced input/outputs. Use either mono plugs, or use stereo
plugs to link the ring and shaft (or pins 1 & 3 in the case of XLR
connectors).
Fig. 6.2: XLR connections
+
14
/UB1832FX
-PRO -PRO
6. INSTALLATION
/UB2222FX /UB2442FX
-PRO
Fig. 6.3: 1/4" mono plug
Fig. 6.4: 1/4" stereo plug
Fig. 6.5: Insert send/return stereo plug
Fig. 6.6: Stereo plug for headphones connection
-PRO