Terminals; Terminals For The Terminal Block - IDEC KW2D Series User Manual

Chapter 3 Installation and Wiring
• Precautions When Inserting Wires
• Crimping dimensions: W2.1×H1.48 mm
Maximum connectable crimping size is W2.1×H1.48. Make sure that the ferrule size will be smaller than this dimension. (Recommended
crimping tool, see "Recommended Tools" on page 3-15. )
• Connect the ferrules to the terminal block with the direction shown in the following diagram.
Ferrule: Longer direction is horizontal
• Do not insert the ferrules with the direction shown in the following diagram. The clamp and spring may break and no longer function.
Ferrule: Longer direction is vertical

Terminals

This section describes the type and usage method of terminals.

Terminals for the Terminal Block

• Choose an appropriate ferrule for the wire.
• For details, see "Wire Size and Recommended Ferrules" on page 3-14.
• Cut the wire carefully to get a flat end.
• Make sure that ferrule sleeve is completely filled by the conductor. Depending on the cross section, the conductor should protrude
approx. 0 to 1 mm from the ferrule sleeve.
• When crimping, refer to the instructions of the crimping tool.
• Crimping dimensions: W2.1×H1.48 mm
Maximum connectable crimping size is W2.1×H1.48. Make sure that the ferrule size will be smaller than this dimension. (Recommended
crimping tool, see "Recommended Tools" on page 3-15. )
Max. 2.1mm
• If a tool other than the recommended crimping tool is used, the ferrule may not be crimped to the appropriate size and the
Caution
Power supply terminals may be deformed and may not operate normally.
• Pin crimp terminals cannot be used.
3-12
0 to 1 mm
Max. 1.48mm
KW2D Series Smart RFID Reader User's Manual
KW9Y-B2163