Chevrolet Trailblazer 2020 Owner's Manual page 88

Chevrolet Trailblazer Owner Manual (GMNA-Localizing-SE Asia/CenAmer/
Carib-13517615) - 2020 - CRC - 3/22/19
88 Instruments and Controls
seconds. Then the control indicator
stops flashing and illuminates until
the driver safety belt is fastened.
Additionally, if the driver remains
with the safety belt unfastened while
the vehicle is moving, after reaching
a specific distance or speed, a
chime sounds and the control
indicator flashes for several
seconds.
If the driver safety belt is already
fastened, neither the control
indicator nor the chime comes on.
See Safety Belts 0 42.
If Safety Belt Reminder is active the
Rear Parking Assistance chime will
not operate.
Passenger Safety Belt
Reminder (If equipped)
C
for passenger's seat illuminates
or flashes red.
When the vehicle is started this light
flashes and a chime may sound to
remind passengers to fasten their
safety belt. Then the light stays on
solid until the belt is buckled.
This cycle continues several times if
the passenger remains or becomes
unbuckled while the vehicle is
moving.
If the passenger safety belt is
buckled, neither the chime nor the
light comes on.
The front passenger safety belt
warning light and chime may turn on
if an object is put on the seat such
as a briefcase, handbag, grocery
bag, laptop, or other electronic
device. To turn off the warning light
and/or chime, remove the object
from the seat or buckle the
safety belt.
Rear Passenger Safety Belt
Reminder (If equipped)
for rear passenger's seat
appears on Driver Information
Center.
When the engine starts, the
symbols will be displayed in the
lower part of the DIC. If a rear seat
belt is buckled, the corresponding
symbol will dim.
Once the vehicle is travelling over
10 km/h for approximately
10 seconds, the symbols will
extinguish. If a rear seat belt is
unbuckled whilst driving, a chime
will sound and the corresponding
symbol will flash in the DIC.