Advertisement
Quick Links
Advertisement
Related Manuals for Equator Super Combo EZ 5000 CV
Summary of Contents for Equator Super Combo EZ 5000 CV
- Page 1 ADVANCED Appliances Super Combo ALL-IN-ONE WASHER + DRYER Model: EZ 5000 CV...
- Page 2 ..............Introduction ..............Warranty .............. Technical Data ..........Important Safety Instruction ..............Helpful Hints .............. Pre-installation ............Diagram of the Combo ............Installation Instruction ............Unpacking-leveling ..............Electrical ..............Plumbing ..............Ventilation ......... Built-In, Recessed, Closet, Alcove Installation ..........PROGRAM SELECTION CHART ............
- Page 3 Congratulations on your new Super Combo. In addition to its contemporary design, this is highly sophisticated engineered product that will give you many years of Satisfaction. The Washer-Dryer’s sleek and compact size design makes it a perfect appliance for any kitchen or Laundry Room Refresh Function and weather.
-
Page 4: Warranty Information
(90 days), in India. WARRANTY Equator Appliances undertakes to the consumer-owner to repair or, at our option, to replace any part of this product which proves to be defective in workmanship or material under normal personal, family or household use within India, for a period of 2 years parts &... - Page 5 EXCLUSIONS In no event shall Equator Appliances be liable for incidental or consequential damages or for damages resulting from external causes such as abuse, operation misuse, neglect, alterations, normal wear and tear, incorrect voltage or acts of God. This warranty does not cover service calls which involve defective workmanship, damage due to other products while combined use with this product or materials covered by this warranty.
- Page 6 EZ 5000 CV 220-240V 50Hz 16 Amp 150 W 500 W 9 kg 1400 RPM 0.03MPa < P < 1MPa 85 x 60 x 63.5 (cm) 81 kg Note: All rights reserved. Designs, Specifications and Manual subject to change without notice...
- Page 7 To reduce the risk of fire due to contaminated loads, the final part of a tumble dryer cycle occurs without heat (cool down period). Avoid stopping a tumble dryer before the end of the drying cycle unless all items are quickly removed and spread out so that the heat is dissipated.
- Page 8 MODEL No: SERIAL No: 1400 rpm 9 kg. USE FRONT LOADING DETERGENT: Front Loading detergent, Front Loading detergent The unit must be installed on a strong leveled surface in a protected, dry and well-ventilated area, with a power and water supply of sufficient capacity and a sufficient outlet in close proximity. 240V/50Hz...
- Page 9 Shipping Bolts (3 Nos.) Factory supplied accessories Blanking Cap s - 3 Vent Adapter Water Inlet Hose U-Connector (To cover shipping bolts hole) (For drain hose) To connect vent hose to exhaust fan...
- Page 10 Handling Installation area Please handle the machine carefully and use appropriate means while lifting and moving the machine so that it does not get damaged. Do not drag the machine on floor. Do not hold on to Appliance stability is very important otherwise protruding parts when lifting washing machine could “wander”...
- Page 11 packaging The power cord can bolts be accessed by removing the 3 shipping bolts. (Figs. 2 & 3). by the bolts with the caps provided (Fig. 4). (Fig. 5). Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5...
- Page 12 240V/50Hz...
- Page 13 on machine 4 cm 60 cm - 100 cm Height difference between the installation location of the washing machine and the drainage point: Minimum 60 cm to Maximum 100 cm Attach water drain hose to U-Connector. Hook the U-Connector over the side or stand pipe (Fig 8.) When the water is being drained, check that the water flow out of the hose is adequate.
- Page 14 CONDENSING DRY To use dryer in Condensing Mode: 1. Ensure metal vent cover (1) is installed over exhaust fan as shown in Fig.9 2. Power on the machine 3. Press "Dry Only" button to set the machine on drying cycle. 4.
- Page 16 MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALATION 5 cm 7.5 cm BUILT-IN, RECESSED, CLOSET AND ALCOVE INSTALLATION n a built-in, recessed area, closet or alcove. centimetres and is the minimum acceptable. 5 cm either side and 7.5 cm front and rear. 2.5 cm 2.5 cm 5 cm...
- Page 17 1. WASH & DRY, WASH ONLY, DRY ONLY Description of Wash features Drying heat Program Water Temp/Spin rpm/Duration Load & approx time Max heat - 1300W Mixed Clothes 1. DAILY Warm 30 / 1200 / 60 mins 90 mins (Shirts, Trousers etc) Max heat - 1300W 2.
- Page 18 For small items such as socks, children’s garments and small towels please use a Washing Net Bag. If you are using Wash Only cycle, you can fill the drum. If you are using Wash + Dry cycle, please do not load clothes more than 2/3 full. Use Front Load detergent, as per direction.
- Page 19 Sports REFRESH DRY TIME DRY SAREE Drum-Clean Wool Quick Delicate Prewash Sanitize (+Heavy) Hold 3 sec to Reload Hold 3 sec Allergy Bedbug Heavy Hold 5 sec SPIN mode Vented / mode mode Ventless mode selection button mode Press this button to select the dry level for a Sensor Dry cycle. The default is Normal and you can select Extra, Low or Damp Dry.
- Page 20 Dry level options Hold 3 sec Hold 5 sec A. How to Run Wash + Dry Cycle 1. Press POWER button 2. Press START Default cycle is DAILY - If required you can change to desired washing cycle based on type of clothes B.
- Page 21 Reload Feature PRESS START/PAUSE for 5 seconds. How to stop the wash cycle - The wash program can be stopped at any time. - PRESS START/PAUSE for 5 seconds - PRESS POWER button for 3 seconds to turn off the machine How to stop the dry cycle - PRESS POWER button for 3 seconds to turn off...
- Page 22 - Switch off the Washer - Open the service flap. (bottom right corner) (Fig.14) - Carefully unscrew the coin-trap cover. Warning: Some residual water will flow out. (Approx 1 Cup) [Fig.15] - Remove foreign objects/fluff from inside and clean the interior. (Fig.16) - Make sure the pump impeller wheel located behind the water filter is able to rotate.
- Page 25 101 cm Front Load detergent enough Is the dryer knob in the correct position for the drying cycle ? Is drying cycle selected (Time Dry/Sensor Dry) ? Condensation at soap dispenser Slight condensation can occur at soap dispenser and will evaporate. This is normal...
- Page 26 To Order parts: www.EquatorAppliances.in...